Model No. : LSDS01

Overview

The LEN SD Splitter is suitable for additional monitor feeds; remote camera locations and situations where size and weight are critical factors – such as racing cars, bikes and other sporting and research applications.

Each is built in an ABS enclosure fitted with three female BNC connectors.

Features

• Miniature passive Splitter – no power required
• Broadcast quality signal up to 360 MHz
• Size 45 x 30 x 15 mm – weight less than 30 gm
• Ideal for permanent and temporary installations
• SD SDI or ASI

Description / Details

Designed to split signals up to 360 MHz the SD Splitter is ideal for permanent installation in a studio or for temporary situations.

Two (or more) Splitters can be used in series to provide up to 8 individual feeds over shorter distances. Actual distance dependant on original signal strength and cable quality.

This splitter also works well with the 270 MBit ASI Signal format.

Further Notes

To guarentee the specified performance the input should be fed with a source impedance of 75 ohms and both outputs should be terminated with 75 ohms. Therefore, if an output cable is not present, a 75 ohm termination should be fitted. This should be specified to operate over the full SDI bandwidth in use.

However, typical feedback from End Users is that not terminating an unused output does not cause significant reduction in performance.

Optional accessories: The LMPS02 Rack Frame is a 1U 19-inch panel, finished in black, punched to take up to eight Splitters mounted from the rear by means of the mounting screws, the BNC connectors facing out of the rack. If it is desired to have the connectors facing into the rack, the Splitters may be reversed, revealing the Splitter modules which will protrude 15mm from the surface of the panel.